Veeder Root TLS450 PLUS Upgrade Minot AFB, ND

Bid Detail Page

Hi,

Federal Contract Opportunity

Last Updated on 01 Jul 2025 at 8 PM

Solicitation

Minot air force base North dakota

Details

Solicitation ID FA4528-25-Q-SP02

Source Signup to get source link

Posted Date 01 Jul 2025 at 8 PM

Response Date 08 Aug 2025 at 2 PM

NAICS Category

Product Service Code

Set Aside Total Small Business (SBA) Set-Aside (FAR 19.5)

Contracting Office Fa4528 5 Cons

Agency Department Of Defense

Location Minot air force base North dakota United states 58705

Possible Bidders

Henry Schein Incorporated

Carmel Melville Tampa Roseburg

National Industries For The Blind

Wayne Earth city Alexandria

Dental Health Products Incorporated

Youngstown New franken

Henry Schein Incorporated

Carmel Melville Tampa Roseburg

Federal Prison Industries Incorporated

Herlong Phoenix Lompoc Jesup Bastrop Sandstone Victorville Otisville Manchester Greenville Lewisburg Ray brook Waseca Seagoville Atlanta Alderson Bruceton mills Inez Texarkana Minersville Tucson Washington Miami Fairton Lewis run Coleman Pollock El reno Terre haute Ashland Memphis Dublin Oxford Danbury Marion Safford San pedro Littleton Lexington Fort dix Beaumont Bennettsville Petersburg Allenwood Talladega Edgefield Big spring Pekin Glenville Leavenworth Butner Fort worth Loretto

Sign up to access Documents

Signup now

Work will be to purchase and install replacement of existing Veeder Root 350PLUS to Veeder Root 450PLUS systems in one (1) Squadron of five (5) Missile Alert Facilities (MAF) and fifty (50) Launch Facilities (LFs). Two (2) additional Squadrons with five (5) MAFs fifty (50) LFs for each squadron (possible total of 15 MAFs and 150 LFs) will be included under this contract as options and one (1) additional option for seven (7) extra Veeder Root TLS 450PLUS consoles & accessories. Locations under this contract are located in the Missile Complex at Minot Air Force Base (AFB), which is located throughout northwestern North Dakota. Site order shall be set by the Government and can be changed to meet mission requirements at no additional cost to the Government.
Please see attached quote sheet (attachment 3) for site locations and option CLIN's.

The work shall include but is not limited to the replacement of the existing Veeder Root 350/350PLUS fuel monitoring systems with the new Veeder Root 450PLUS systems. All wiring shall be replaced with the Veeder Root network (i.e. from the console out to each sensor, probe, alarm and switch). Wire is required to be EMI shielded cable for all probes and sensors at LFs. The contractor is to follow all Veeder Root requirements for proper installation and setup. See Manual No: 577014-073 and Manual No: 577014-074. W3 MAF 450PLUS Programming Instructions W3 LF 450PLUS Programming Instructions for Air Force specific programming requirements. The contractor or subcontractor must have the following minimum training certificates to install and set up the equipment: Level 2 or 3 Service Technician Certification and Level 1 - Installer Certification. Contractor must have North Dakota licensed master electrician on-site working and must be physically on site during electrical installations. The conduit must be properly sealed in accordance with the latest National Electric Code (NFPA 70) and the Code for Motor Fuel Dispensing Facilities and Repair Garages (NFPA 30A). The contractor shall comply with applicable Occupational Safety and Health Administration (OSHA) directives.

**PLEASE NOTE: SITE VISIT MANDATORY TO PROVIDE A QUOTE**