1 Perform Ultrasonic Thickness Measurements
2 Perform Ultrasonic Thickness Measurements
3 Perform Hull and Structural Plating Repairs in Various Compartments - Eroded Welds (Steel)
4 Clean and Inspect Dirty Oil Tank
5 Clean and Inspect Oily Water Tank
6 Clean and Inspect Fuel Service Tanks
7 Clean and Inspect Grey Water Tank
8 Clean and Inspect Sewage Tank
9 Clean Grey Water Piping System
10 Clean Sewage Piping System
11 Inspect Pilothouse Deck
12 Inspect RHIB Notch Skid Pads
13 Renew RHIB Notch Skid Pad Studs
14 Realign Main Engine/Reduction Gear
15 Remove, Inspect and Reinstall Propeller Shafts
16 Repair Shaft
17 Straighten Shaft
18 Renew Intermediate Water-Lubricated Shaft Bearing
19 Renew Aft Water-Lubricated Shaft Bearing
20 Renew Intermediate Bearing Carrier
21 Renew Aft Bearing Carrier
22 Remove, Inspect, and Reinstall Propellers
23 Perform Minor Repair and Recondition of Propeller
24 Renew Depth Indicating Transducer
25 Renew Sea Valves and Inspect Associated Piping & Strainers
26 Remove, Inspect, and Reinstall Rudder Assemblies
27 Remove, Inspect and Reinstall Stern Launch Door, & Inspect Door Pivot Pins, Bushings, and Washers
28 Preserve Underwater Body - "Partial"
29 Preserve Underwater Body - "100%"
30 Preserve Stern Tubes
31 Modify and Renew Cathodic Protection System
32 Renew Transducer Fairing
33 Routine Drydocking
34 Provide Temporary Logistics
35 Renew Sounding Tube Caps
36 Install AFFF Bilge Sprinkler System (EC 087-A-024)
37 Modify and Preserve the Forepeak (EC 087-A-033)
All welding and brazing shall be accomplished by trained welders who have been certified by the applicable regulatory code performance qualification procedures. In accordance with FAR 19.1305, if your firm is HUBZone certified or FAR 19.1404 if your firm is SDVOSB or FAR 19.501 if your firm is a Small Business and intends to submit an offer on this acquisition, please respond by e-mail to [email protected] or by fax (757) 628-4676. Questions may be referred to Nancy Brinkman at (757) 628-4579.
Your response is required by January 27, 2010. All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone, Service-Disabled Veteran-owned Small Business set aside or Small Business set aside. Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone or SDVOSB small business set aside, or a Small Business set aside, will be posted on the FedBizOps website at http://www.fedbizopps.gov.
In response please include the following: (a) a positive statement of your intent to submit a bid for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amount, points of contact and telephone numbers; (c) past performance references with points of contact and phone numbers. At least two (2) references are requested, but more are desirable.