Maintenance and Logistic Command, Pacific is looking for certified Small Business firms that may be interested in and have the capabilities to perform the DRYDOCK & REPAIRS of USCGC MIDGETT (WHEC 726), a 378’ High Endurance Cutter, homeported in Seattle, Washington. All work shall be performed at the contractor facility during the period of 05 April 2006 to 30 May 2006. Performance is geographically restricted to within 200 road mile of cutter permanent berth in Seattle, Washington. Request for Proposal (RFP) will be issued on or about 10 November 2005 with a closing date of 13 December 2005. Offerors are advised that the solicitation, specification and other notifications can also be accessed on the web at: www.eps.gov. Work items will include: production control; Gantt bar chart; chain locker clean and inspect; hull plating renewal; hull plating; underwater body inspect; hull plating; underwater body ultrasonic testing; windlass room structural repairs; appendages (underwater) air test; appendages (underwater) leak test; appendages (underwater) preserve; internal; propulsion shaft fairwaters and rope guards inspect and repair; void (non-accessible) leak test; voids (non-accessible) preserve; internal; tanks (hydraulic oil storage and service) clean and inspect; tanks (MP fuel stowage and overflow) clean and inspect; tanks (aviation fuel stowage) clean and inspect; propulsion shaft coating inspect and test; propulsion shaft seals (mechanical) inspect and clean; propulsion shaft bearings (external) check clearances; controllable pitch propeller system general maintenance; hubs general maintenance; propeller clean and inspect; inspect and test circuit breakers; fathometer transducers general maintenance; inspect and test circuit breakers 400Hz; critical vent fans overhaul; vent ducts (engine and motor rooms) commercial cleaning; vent ducts (galley and pantry) commercial cleaning; sea strainers (all sizes); sea valve (<=2.5 inches) renewal; sea valve (> 2.5 inches) overhaul; evaporator pumps replacement; potable water pneumatic tank relief valves renew; potable water pneumatic tanks; clean; inspect and hydro; steam safety and relief valves overhaul test and set; fuel oil manifold valve overhaul; compressed air receivers (all) clean; inspect and hydro; rudder and rudder stock removal and inspection; rudder inspect and repair; thruster unit (general) overhaul; thruster unit hydraulic accumulators inspect and hydro test; anchor windlass (gen) level 2 inspect and repair; oily water separator overhaul; oily water separator tank repairs; hull plaint; underwater body preserve; partial; rudders (exterior) preserve; cathodic protection; zinc anode renewal; sea trails; temporary services; drydock provide; drydocking accomplish; voids (accessible) clean and inspect; ac chill water sys clean and inspect; DC stores bilge preservation; engine room bilge preservation; forward sewage bilge preservation; pump room #1 bilge preservation. Interested small business firms must meet the requirements set forth in FAR 52.219-14. The NAICS code assigned to this procurement will be 336611 with a size standard of less than 1,000 employees. FedTeDS: In order to open and download the specifications, the vendor must register in FedTeDS (using their CCR). E-mail will arrive in 48 hours to the vendor authorizing access. Go to www.fedbizopps.gov to the solicitation to link to the specifications.

Bid Protests Not Available