The following Question and corresponding Answer is provided:

Question 1:
TS 3.3.2, Table 1, page 10, 1^st item specifies multipoles should be measured at 12.5mm gap. Other parts of the table specify 15mm gap. At which gap must the Table 1 multipole specifications be met?

Answer 1:
That is a typo.   The correct value is 15mm. 

Except as noted herein, all requirements as set forth in RFP solicitation request 166033, as well as any previous amendments, remain unchanged.

Any questions should be addressed in writing to the attention of George Woods.