Remove one (1) duplex vacuum control panel and replace it with a duplex control panel for Islamorada's wastewater system. In order to properly remove the existing duplex vacuum pump control panel and install the duplex control panel described on Task 2 below, Contractor shall: Conduct a Site inspection of the existing control panel and its condition, verify and trace existing wiring. Verify the integrity of existing as-built-drawings. Disconnect and remove the existing control panel. Pour a new concrete pad to mount panel. Allow sufficient time for concrete to cure. Mount new panel in place. Field the terminations of previously disconnected wiring. Configure variable frequency drives, instrument signal loop checks and commission services. Task 2- Supply and Install new Duplex Control Panel Contractor shall supply and install a Duplex Control Panel containing the following components/parts: ENCLOSURE NEMA 12 PAINTED STEEL- FREE STANDING MAIN CIRCUIT BREAKER W/DISCONNECT HANDLE POWER DISTRIBUTION BLOCK 480VAC SURGE PROTECTION 120VAC SURGE PROTECTION MOTOR CIRCUIT PROTECTION CIRCUIT BEAKERS CONTROL CIRCUIT BREAKERS PROGRAMMABLE LOGIC CONTROLLER W/ I/O & ACCESSORIES (COMPACTLOGIX) HMI SCREEN (PANELVIEW PLUS 1500) CHART RECORDER PRESSURE TRANSMITTER VARIABLE FREQUENCY DRIVE (QTY. 4 EA) UNMANAGED ETHERNET SWITCH UNINTERRUPTIBLE POWER SUPPLY WITH BATTERIES & ACCESSORIES POWER SUPPLY 24VDC RADIO WITH POLYPHASER SOLID STATE CONTROL RELAYS MINIATURE CONTROL RELAY WITH SOCKET CONTROL RELAY WITH SOCKET CONTROL TIMER WITH SOCKET FUSES WITH FUSE HOLDERS SIGNAL SURGE PROTECTION DUPLEX RECEPTABLE INTERIOR PANEL LIGHTING WITH TOGGLE SWITCH PANEL HEATER WITH THERMOSTAT TERMINAL BLOCK WITH ACCESSORIES GROUND BAR/LUGS

Bid Protests Not Available