G
All work will be performed at the contractor's facility. This vessel is geographically restricted to 600 Nautical Miles one way, or 1,200 Nautical Miles, round-trip from the cutters homeport of Miami, FL. The performance period will be FORTY FOUR (44) calendar days with a start date of 10 August through 23 September 2011.
The scope of the acquisition is for the Drydocking and repairs of the USCGC CHINOOK (WPB-87308), an 87 Foot Patrol Boat. This work will include, but is not limited to:
Perform Ultrasonic Thickness Measurements
Perform Ultrasonic Thickness Measurements
Dirty Oil Tank, Clean and Inspect
Oily Water Tank, Clean and Inspect
Tanks (MP Fuel Service), Clean and Inspect
Pilothouse Deck (Aluminum), Inspect, Preserve, and Renew Electrical Matting
Depth Sounder, Capastic Fairing, Renew
Main Engine/Reduction Gear, Realign
Propulsion Shafts, Remove, Inspect, and Reinstall
Propulsion Shaft, Repair
Propulsion Shaft, Straighten
Intermediate Water-Lubricated Shaft Bearing, Renew
Aft Water-Lubricated Shaft Bearing, Renew
Intermediate Bearing Carrier, Renew
Aft Bearing Carrier, Renew
Stern Tubes, Interior Surfaces, Preserve 100%
Stern Tubes, Interior Surfaces, Repair
Propellers, Remove, Inspect, and Reinstall
Propeller, Minor Repair and Recondition, Perform
Fathometer Transducer, Renew
Speed Log, Transducer and Skin Valve, Clean and Inspect
Sea Water System (Valves, Strainers, Piping), Clean, Inspect, and Repair
Rudder Assemblies, Remove, Inspect, and Reinstall
RHIB Notch Skid Pads, Inspect
RHIB Notch Skid Pad Studs, Renew
Stern Launch Door, Remove, Inspect, and Reinstall
Grey Water Holding Tank, Clean and Inspect
Sewage Holding Tank, Clean and Inspect
Grey Water Piping, Clean and Flush
Sewage Piping, Clean and Flush
U/W Body, Preserve ("Partial-33%")
U/W Body, Preserve ("100%")
Cathodic Protection / Zincs, Renew
Drydocking
Temporary Services, Provide
Telephone Service, Provide
Bilge Surfaces (Lazarette), Preserve ("Partial")
Ventilation System, Engine Room Supply and Exhaust Fan Assemblies, Clean and Inspect
Forepeak, Modify (EC 087-A-33)
Engine Exhaust Pipes, Renew (EC 087-B-043)
Engine Exhaust Pipes, Port and Starboard Exhaust Blankets, Renew
All welding and brazing shall be accomplished by trained welders who have been certified by the applicable regulatory code performance qualification procedures. In accordance with FAR 19.1305, if your firm is HUBZone certified or FAR 19.1404 if you firm is SDVOSB or FAR 19.501 if your firm is a Small Business and intends to submit an offer on this acquisition, please respond by e-mail to [email protected] or by fax (757) 628-4676. Questions may be referred to Susan Kreider at (757) 628-4644.
In response please include the following: (a) a positive statement of your intent to submit a bid for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amounts, points of contact and telephone numbers; (c) past performance references with points of contact and phone numbers, at least two (2) references are requested, but more are desirable.
Your response is required by February 25, 2011. All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone, Service-Disabled Veteran-owned Small Business set aside or Small Business set aside. Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone or SDVOSB small business set aside, or a Small Business set aside, will be posted on the FedBizOps website at http://www.fedbizopps.gov.